Vehicle Fire & Engine Management System
Early warning of fire or engine failure conditions in commercial vehicles
SPECIFICATIONS
- 24v DC or 12v DC operation.
- 20 x 4 line LCD display.
- Real Time clock, date/time event recording.
- GUI for computer downloads to evaluate data, via BLE module.
- 12v battery backup.
- 12v DC output for smoke detectors.
- Two TYRE fire zones, fire and fault reporting.
- ENGINE fire zone, fire and fault reporting.
- Canistor Pressure Monitoring.
- SMOKE detector fire zone.
- OIL pressure monitoring.
- OIL temperature monitoring.
- WATER level monitoring.
- ALTERNATOR charging monitoring.
- SPEED or EXCESSIVE IDLE monitoring.
- Separate RELAY box controller monitoring.
- Physical size: 150mm x 97mm x 35mm.
- RELAY1 output for fire extinguish.
- RELAY2 output for external siren.
- RELAY3 output for engine shutdown.
- SILENCE and manual DISCHARGE push buttons.
OPERATION
- Power up routine checks all the incoming zones and then continuously monitors for fire, fault or engine failure conditions.
- The VMS1 will beep and flash the LCD backlight on any fault condition.
- For fire conditions the extinguish relay will activate for 10 seconds.
- Faults on the fire zones will be displayed only.
- For engine fault conditions the VMS1 will beep and flash the LCD backlight slowly, the engine cut relay will energise after 15 seconds of beeping.
- The SILENCE button may be pressed to stop the beeping at any time.
- The DISCHARGE button will manually extinguish the fire. This button must be held in for more than 2 seconds.